KORG X50 - Manual (Page 90)

Effects settings
84
Effect settings in combina-
tion, and Multi
Routing
In Combination and Multi modes, you can specify
the routing of each timbre/track to the insert effect
and master effects. These settings are made in the
same way in each of these modes. We will be using
the example of Combination mode in our explana-
tion here.
1. Access the COMBI 8: Ed–InsertFX, BUS page.
2. In “BUS Select,” specify where the output of
each timbre will be sent. (See diagram below)
L/R: The output will be sent to (MAIN
OUTPUT) L/MONO and R.
Note: After passing through the master EQ, the
sound will be sent to (MAIN OUTPUT) L/
MONO and R.
IFX: The output will be sent to insert effect IFX.
1, 2, 1/2: The output will be sent to
(INDIVIDUAL OUTPUT) 1 or 2.
Note: It will not be sent to the insert effect, the
master effects, or the master EQ.
Off: The sound will not be sent to (MAIN
OUTPUT) L/MONO, R, (INDIVIDUAL
OUTPUT) 1 and 2. After passing through the
master effects, the sound is sent to the MAIN
OUTPUT. Choose this setting if you want to
send the sound in series through the master
effects at the send level specified by “MFX
Send.” (See diagram below)
3. “S1” (Send1(MFX1)), “S2” (Send2(MFX2))
specifies the send level from each timbre to the
master effects.
This can be set only if “BUS Select” is set to L/R
or Off.
The actual send level will be the send level of
each timbre multiplied by the send level of each
oscillator of the program selected for the
timbre. If the send level of a program is 0, the
actual level will be zero even if the send level
setting is raised here.
If IFX is selected for “BUS Select,” set the send
levels to the master effects by adjusting the “S1
(Send1(MFX1))” and “S2 (Send2(MFX2))”
parameters (COMBI 8: Ed–InsertFX, Setup
page) located after the signal has passed
through the insert effect.
Selecting an insert effect, and rout-
ing after the insert effect
The Setup page displays the state of the routing
and insert effect settings.
Pan
Timbre / Track 1 BUS Select
= L/R
Send1
Select from:
(DKIT)
L/R
IFX
1
2
1/2
Off
BUS Select
= L/R IFX BUS IFX
MFX2
MFX1
mono
mono
Return1 / 2
Master EQ AUDIO OUTPUT
(MAIN) L/MONO, R
Timbre / Track 2
Timbre / Track 3
BUS Select
= Off
Timbre / Track 4
BUS Select
= 1/2 Timbre / Track 8
BUS Select
= 2
Track 16
IFX / Indiv.Out
BUS Select
Insert Effect
Post IFX
Pan(CC#8)
BUS Select
Select from:
L/R
1
2
1/2
Off
Send2
stereo
Master Effects
AUDIO OUTPUT
(INDIVIDUAL)1/2
L/R BUS
stereo
mono x 2 mono x 2
BUS Select
= 1
BUS Select
= IFX
stereo
stereo
Chain
COMBI/MULTI 8: Insert Effect
Post IFX
Send1 / 2
COMBI/MULTI 9: Master Effect
Routing
Pan (CC#8)
BUS Select Insert Effect
IFX On Insert Effect
Send2(MFX2)
IFX On/Off Send1(MFX1)