KTM 250 EXC RACING - Manual (Page 41)

ENGLISH
40
Fuse (MXC/EXC)
The fuse 1 is located in the starter relay of the E-starter 2 underneath the
left side paneling.
Having removed the left side paneling, the air box cover and the protection
cover
A , you will be able to see the fuse.
The following loads are connected to it:
– E-starter system
– horn
– flasher lights
The starter relay also contains a (10 amp) spare fuse 3 .
Replace a blown fuse only with an equivalent one. If a new fuse that has
just been installed gets blown again, you are strongly advised to have it
inspected by a KTM dealer.
The fuse capacity is 10 Ampere.
! CAUTION !
U NDER NO CIRCUMSTANCES IS A STRONGER FUSE ALLOWED TO BE INSTALLED OR A FUSE
ALLOWED TO BE “ REPAIRED ”. A N IMPROPER TREATMENT COULD DAMAGE THE WHOLE
ELECTRICAL INSTALLATION .
Replacing headlight lamp/parking light lamp
Loosen both rubber bands and tilt headlight mask to the front. Pull the
parking light lamp with holder
4 carefully out of the reflector. Pull connector
5 off the headlamp and remove rubber cap 6 . Disengage retaining clip
and take bulb out of reflector. When changing the parking-light lamp,
simply pull it out of the holder.
Insert the new lamp such that the noses 7 engage in the recesses 8 .When
doing so, do not touch the glass body of the lamp so that it remains free
from fat. Engage retaining clip, mount rubber cap and connector. If the
parking-light lamp is to be replaced, simply insert it in the holder. Reinsert
the parking-light lamp together with the holder.
Engage the bottom end of the headlamp mask at the retaining pins and fix
the mask by means of the rubber bands.
1
2
3
A
7
5
6
4
8