Kenwood Excelon DDX7015 - Manual (Page 78)

Setup Menu
English
78 English
Security Code Setup
You can set a security code to protect your
receiver system against theft.
When the Security Code function is activated, the
code can't be changed and the function can't be
released.
Note, the Security Code can be set as the 4 digit
number of your choice.
If is not shown, touch
or to display it.
1 Returns to the Control screen of the previous
source.
2 Calls the Sound Effects Menu. (see page 84)
3 Calls the Setup Menu.
4 Allows you to start security code registration.
5 Turns the SI function On or Off.
If turned "On", the burglar alarm lamp flashes
when the vehicle ignition is off.
If you have already completed the code
registration, the
is not displayed. S e t
Secur i t y Set Up
Secur i t y Set Up
Display the Security Code Setup screen 1
1 Enters a security code.
2 Clears your entry.
3 Cancels the registration and returns to the
Security Code Setup screen.
4 Enters the security code.
—
Input a four-digit number.
Reenter the same security code as that you have
entered in Step 3 for confirmation.
If you enter a different security code, the screen
returns to Step 3 (for the first code entry).
Your security code has been registered.
If you press the Reset button or if you disconnect
your Receiver from the battery after the code
registration, you need to enter the registered
security code.
See below for details.
E n t e r
Register the security code again 6
Reenter the security code 5
E n t e r
Register your security code 4
9 0
Enter a security code 3
S e t
Start the security code registration 2
M e n u S e c u r i t y C o d e
Se c u r i t y
S e t
Set Up
SRC
Audio
S I O f f On
2
1
3 4
5 5
E n t e r C a n c e l C l e a r
* * * *1 s t
1 2 3
4 5 6
7 8
0
9
Pa s s Wo r d
2 3 4
1
DDX7015/7045_K(En)v3.9 04.4.18 9:42 AM ページ78