Kuhn Rikon 3000 SERIES 3030 - Manual (Page 23)

23
3000STOPR005810R082503
KUHN KNIGHT INC.
1501 West 7th Ave. Brodhead, WI 53520-0167
701 Cherry Ave. Greeley, Co. 80632
INSPECTION & ADJUSTMENTS:
Electronic Scale (optional)
Scale Indicator: Refer to the electronic scale operators manual for adjustment information. The operator’s manual
for the Electronic Scales should be kept with this manual. Additional scale manuals may be obtained through
Kuhn Knight Inc.
Load cells and weigh bars should be kept clean, dry & lubricated to insure dependability.
Normal scale activity:
Some warm up scale drift may occur after the scale is turned on but should zero balance within 10-15 minutes.
Scale may zero shift over night due to temperature changes.
Weight may change slightly due to terrain changes when mixer is moved.
Vertical check bolts must not be tight
(and should be free to rotate by hand) and
need not less than 1/16” and no more than
3/32” free play when properly adjusted on
level ground.
Check arm assembly must be free to slightly
rotate by hand when mixer is on level ground
(see diagram), with mounting bolts tight.
PIN CHECK BEARING should be centered on
the pin when mixer is on level ground. Adjust-
ment can be made by loosening the mounting
bolts, centering pin check assembly on the pin
and tightening the mounting bolts. If bushing
cannot be centered load cells may require
adjustment.
INSPECTION & ADJUSTMENTS
ALWAYS STOP MIXER AND LOCK OUT POWER BEFORE SERVICING, REPAIRING, OR CLEANING.
IF WORK MUST BE PERFORMED INSIDE THE MIXER, STOP MIXER AND LOCK OUT POWER AND
PUT A PROTECTIVE COVER OVER THE AUGER KNIVES TO AVOID INJURY. THE HOPPER FLOOR
MAY BE SLIPPERY, AND THE REEL AND AUGERS WILL SPIN WHEN STEPPED ON. USE CAUTION
WHEN STEPPING OR STANDING INSIDE THE UNIT. USE SAFE SHOP PROCEDURES AND EXERCISE
CAUTION WHEN WORKING ON THIS MIXER!