Kuhn Rikon 3000 SERIES 3030 - Manual (Page 25)

25
3000STOPR005810R082503
KUHN KNIGHT INC.
1501 West 7th Ave. Brodhead, WI 53520-0167
701 Cherry Ave. Greeley, Co. 80632
ALWAYS STOP MIXER AND DISCONNECT POWER BEFORE SERVICING, REPAIRING, OR CLEANING.
USE SAFE SHOP PROCEDURES AND EXERCISE CAUTION WHEN WORKING ON THIS MIXER!
It is extremely important that the following lubrication guide be followed:
For lubricating bearings, use a good quality multipurpose grease. Replace all damaged or missing grease zerks
immediately. Always clean zerks before using grease gun. Pump the grease in slowly until a slight bead forms
around the bearing seals. Once a month check lines and connections on grease banks for leaks.
Before operating a new mixer, the roller chains should be liberally lubricated and then the unit operated under
a no-load condition. This break-in period will allow the roller chains to be thoroughly lubricated and thus minimize
heat-up during operation.
The large drive enclosure is designed to be used as an oil bath; fill front enclosure until the oil level reaches the
plug labeled “oil level ”on the enclosure.
* * * shields removed for illustrative purposes
DESCRIPTION
INPUT SHAFT BEARINGS
AUGER BEARINGS (QTY 4 ALL MODELS)
REEL BEARINGS (QTY 2 ALL MODELS)
JACKSHAFT BEARINGS ( 3050,3060,3070,3095 ONLY )
DOOR GUIDES
DOOR LINKAGES
ROLLER CHAIN TIGHTENER PIVOTS
ROLLER CHAIN (WITH 30WT OIL BATH)
CHECK OIL LEVEL PLUG
ROLLER CHAIN (WITH 30WT OIL BATH)
SCALE CHECK ARMS ( 3050,3060,3070,3095 ONLY )
TOP OF PIN CHECK BEARING (3036,3042 ONLY)
WEIGH BARS (3015, 3020,3025,3030 ONLY)
LUBRICATION FOR OPTIONS
12 VOLT HYDROPACK
LUBRICANT
GREASE
GREASE
GREASE
GREASE
GREASE
GREASE
OIL, 30WT
OIL, 30WT
CHANGE OIL, USE
30WT MOTOR OIL
OIL, 30WT
OIL, 30WT
GREASE
DEXTRON ATF
INTERVAL
8-10 HOURS
8-10 HOURS
8-10 HOURS
8-10 HOURS
8-10 HOURS
8-10 HOURS
YEARLY
8-10 HOURS
6 MONTHS
8-10 HOURS
8-10 HOURS
YEARLY
8-10 HOURS
LOCATION
A
B
C
D
E
F
G
H
I
J
K
L
M
LUBRICATION