Kohler COMMAND CH18-745 - Manual (Page 205)

11.20
Section 11
Reassembly
Figure 11-71. Reinstalling SAM Module.
Install Electric Starter Motor
1. Install the starter motor using the two hex. flange
screws. See Figure 11-72. Some inertia-drive
starters have a pinion cover and spacers on the
starter bolts.
2. Torque the two hex. flange screws to 15.3 N·m
(135 in. lb.).
Figure 11-72. Installing Electric Starter Motor.
Figure 11-73. Connecting Leads to Starting Motor.
NOTE: If the engine uses a side mount muffler on the
starter side, be sure to tie the wires close to
the starter to avoid contact with hot exhaust
parts.
Install Fuel Pump
WARNING: Explosive Fuel
Gasoline may be present in the carburetor and fuel
system. Gasoline is extremely flammable and its
vapors can explode if ignited. Keep sparks and other
sources of ignition away from the engine.
1. Install the pulse style fuel pump and lines as an
assembly. Connect the pulse line to the
crankcase vacuum fitting or the valve cover,
whichever source is used.
NOTE: Pulse style fuel pumps may be made of
metal or plastic. See Figure 11-74. If a
new fuel pump is being installed, make
sure the orientation of the new pump is
consistent with the removed pump.
Internal damage may occur if installed
incorrectly.
2. Install the fuel pump using the two hex. flange
screws. Torque the screws to 2.3 N·m (20 in. lb.).
3. On models with a solenoid shift starter, connect
the leads to the solenoid. See Figure 11-73.
Cylinder Baffle Mounting Location
Blower Housing Mounting Location