Kathrein UFD 515 - Manual (Page 15)

Connection and start-up
LNB-supply voltage
If the feed system (LNB) is powered by an external supply voltage and the LNB
supply voltage is not used for switching over polarity (e.g. Kathrein feed system
UAS 330), the LNB supply of the receiver must be set to "OFF" (see section "In-
stallation menu, LNB configuration“).
TV and video recorder connection
Use a SCART cable to connect the satellite receiver (TV SCART) and TV set. ·
·
·
·
If your TV set is equipped for stereo output, you can receive the sound in stereo via
the SCART connection.
Also use a SCART cable to connect the satellite receiver (VCR/AUX SCART)
and the video recorder.
Audio connection
If you wish to reproduce the sound via a hi-fi system, connect a corresponding
Cinch cable from the audio Cinch sockets on the receiver to the input sockets on
your hifi system.
The digital output is designed to facilitate connection to a Dolby Digital System.
Inserting batteries in the remote control
Remove the cover on the battery compartment on the underside of the remote con-
trol.
Insert the two supplied batteries in the remote control. Ensure correct polarity
of the batteries, the + and – markings are indicated inside the battery com-
partment.
Slide the cover back into the casing and lock in position.
Used batteries are special waste! Therefore, do not throw batteries into the house-
hold waste but rather deposit them at a collection depot for old batteries!
15