Kathrein UFD 515 - Manual (Page 30)

Adding/removing satellites
Adding/removing satellites
Setting up a satellite
The LNB can naturally also accommodate new satellites.
For this, the orbit position that you need to take a bearing on must be known. The
“Antenna settings“ menu entry in the installation menu can be used as an aid for
alignment of the antenna.
Arrive to the menu item "LNB configura-
tion" via the main menu
M
and the „In-
stallation“ - submenu with the
ou
and
O
buttons (plus password). Select
this menu item with
O
and can then
enter or select a new satellite.
Remember that your system must be set-
up accordingly!
In the next step, move with
o u
to
e.g. the entry „User1“.
After pressing the
-
or
+
button, the on-
screen display appears shown opposite.
Confirm it with
O.
The following message appears
Changes are being saved
One moment please
You can now make the entries appropriate to your receiving system in the corre-
sponding positions using the
o
,
u
and
-
or
+
buttons and exit the menu by
pressing
L
button three times. At the same time the new station data is stored.
Make the alphanumerical entries using the numerical buttons on the remote con-
trol. For information see section "operating instructions.
To enter a satellite name
You can change the satellite name in the LNB configuration menu using the num-
ber buttons. Refer to section "operating instructions" for information about the exact
procedure.
30