Kenwood VRS-6100 - Manual (Page 25)

25 EN
3 Press and hold the DIMMER key for more than 2 seconds
to select the AUTO REC or MANUAL REC mode.
1 REC mode off
2 "A-REC":
AUTO REC mode
3 "M-REC":
MANUAL REC mode
When the MANUAL REC mode is selected, the input signal is
down-mixed to 2-channel before being output, but no signal is
output if the source is switched to another digital signal. When
the AUTO REC mode is selected, the type of digital signal is
automatically detected and down-mixed to 2-channel even
when the digital signal is switched.
Recording
Analog sources
1 Use the INPUT SELECTOR key (or the input selector key)
to select the source (other than "VIDEO") you want to
record.
2 Put the component connected to the VIDEO jacks to the
record-pause mode.
3 Start playback, then start recording.
÷ Recording may not be normal for some video software. This
is due to the copy guard condition. fi
Digital sources
Switch on the REC MODE to record a digital input source.
Usually use the AUTO REC MODE to record audio input sources.
When the digital mode changes during recording in the AUTO REC
MODE, the audio signal may be interrupted momentarily.
Recording music in AUTO REC or MANUAL REC mode
When a multi-channel source such as the Dolby Digital or DTS input
signal is recorded in AUTO REC or MANUAL REC mode, the signal in the
current multi channel signal can be recorded down-mixed to 2-channel.
INPUT SELECTOR DIMMER
1 Use the INPUT SELECTOR key (or the Input Selector
keys) to select the source (DVD, VIDEO, FRONT AUX) you
want to record.
2 Put the component connected to the VIDEO jacks to the
record-pause mode.
Multi-channel digital signals
(DTS or Dolby Digital) are
down-mixed to 2-channel
before being output fro-m
the analog recording (REC
OUT) jacks.
INPUT SELECTOR
For AUTO REC mode :
A C E R
↓
D A R D V
The display switches automatically.
For MANUAL REC mode :
M C E R
↓
DV M R D
The display switches automatically.
4 Start playback, then start recording.
÷ If the audio reproduction stops in the middle due to change in the
input signals, etc., press the DIMMER key.
*5484/16-27/EN 04.5.17, 8:34 AM 25