Kenwood VRS-6100 - Manual (Page 26)

26 EN
Listening to radio broadcasts
AUTO/MONO BAND
INPUT SELECTOR
MULTI CONTROL @/#
TUNING
1/¡
TUNER
MULTI
CONTROL
%/fi
AUTO 7
BAND
Tuning radio stations
8 ) 8 )
The receiver can store up to 40 stations in the memory and recall them by one-touch operation.
1
Use the INPUT SELECTOR key (or the TUNER key) to select
the tuner.
2
Use the BAND key to select the desired broadcast band.
Each press switches the band.
-- 8 ) 8 )
3
Use the AUTO/MONO key (or the AUTO 7 ) to select the
desired tuning method.
Each press switches the tuning method to either auto or manual tuning.
1 Auto tuning:
The AUTO" indicator lights up
2 Manual tuning:
The AUTO" indicator goes off
÷ Normally, set to "AUTO" (auto tuning). If the radio waves are weak
and there is a lot of interference, switch to manual tuning. (With
manual tuning, stereo broadcasts will be received in monaural.)
4
Use the MULTI CONTROL button (or the MULTI CONTROL % /
fi keys, TUNING 1 / ¡ keys) to select the station.
Auto tuning :
The next station is tuned automatically.
Manual tuning :
Use the MULTI CONTROL button (or the MULTI CONTROL %/fi
keys) to select the desired station.
Presetting radio stations
AUTO/MONO BAND
MEMORY
INPUT SELECTOR
MULTI CONTROL @/#
1
Use the INPUT SELECTOR key (or the TUNER key) to select
the tuner.
2
Press the MEMORY while receiving the station.
)1 7 5 8 )
Proceed to step
3
within 20 seconds. (If more than 20
seconds elapse, press the MEMORY again).
3
Use the MULTI CONTROL button (or the MULTI CONTROL % /
fi keys) to select one of the station presets (1 – 40).
4
Press the MEMORY again to confirm the setting.
• Repeat steps 1, 2, 3 and 4 to store as many stations as
necessary.
• If you store a station at a previously used preset, the old
station will be replaced by the new one.
"AUTO" indicator lights up in the display.
"TUNED" indicator is displayed when a
station is received."ST." indicator lights
when a broadcast is being received in
stereo.
7 5 8 )
*5484/16-27/EN 04.5.17, 8:34 AM 26