Kanguru Solutions iNAS-100 - Manual (Page 32)

System Tools
The following system tools allow optimized maintenance or management of your
Kanguru iNAS 100:
• SNMP Settings
In order to use Simple Network Management Protocol (SNMP) to manage the
Kanguru iNAS 100 's network components, the SNMP service must be started.
• Alert Notification
Configures administrator’s e-mail address and SMTP server’s IP address. In
case of warning or malfunction, an email is automatically sent to the
administrator.
• Restart / Shutdown
Powers off or restarts the Kanguru iNAS 100.
• Hardware Settings
You can enable or disable the following hardware functions of your Kanguru
iNAS 100:
1. Enable LCD panel setting function
Allows you to change the TCP/IP configuration using the LCD panel buttons.
2. Enable configuration-reset switch
Depress and hold the configuration-reset switch for 5 seconds to reset the
administrator password and network settings to the factory default.
3. Enable hard disk standby mode
Hard disk will go to standby mode if there is no access within the period you
specify.
4. Enable buzzer
If the buzzer is disabled, it will not sound when a system error occurs, but the
warning light will still shine.
• System Update
Performs system software updates. Make sure that the image file that you are
about to update is the correct version and read through the instructions carefully.
It is wise to back up all existing data on the Kanguru iNAS 100 prior to performing
system software update. The current settings will remain unchanged after the
system is upgraded.
• Change Logo
You can place a picture that you desire on the upper right corner of the home
page. The size of the picture cannot exceed 20K.
32