Troubleshooting – Kanguru Solutions iNAS-100 User Manual
Page 44
Chapter
6
Troubleshooting
Q1. I can no longer access my iNAS. Is there any way I can reset to the
default settings to start at the beginning?
A1. Yes, there is a reset switch located on the rear panel of the iNAS. Press and
hold the black reset button until the system display “Config reset switch
depressed”. After you have reset the iNAS you should find that the LAN IP
address is now 192.168.1.254. You can now connect to the iNAS through on
of the LAN ports.
Q2. I’m connecting the iNAS behind another router, but I cannot access the
iNAS remotely. What should I do?
A2. First, make sure that your router supports remote access. You then should
make sure that your ISP has not blocked the port that you have selected for
remote access on the iNAS. The default port is 80, but some ISP’s have
blocked this port due to recent virus attacks. If you have selected to use a port
other than 80 you must enter this in the URL. For example, you chose the 88
port because your ISP blocked the default 80 port. Your DNS domain name is
check to make sure your router is set to forward to the iNAS instead of
entering the router’s administration page.
Q3. There is another device on my network using the default IP address of
192.168.1.192. Is there any way I can change the iNAS IP address so I
can configure it.
A3. Yes, press and hold the Switch A button next to the LCD for 2 seconds. You
should enter into the configuration page. You can then enter the Network
settings and assign a Static IP address to the iNAS. Also, make sure to match
the Subnet Mask and Default gateway to your network.
Q4. My iNAS beeps intermittently and always displays “DHCP Linking…”
What does this mean?
A4. The beep indicates that the iNAS has not picked up an IP address from your
network. Please check your WAN settings to assign an IP address. This beep
signal can also be turned off in the administration page.
44