Kanguru Solutions iNAS-100 - Manual (Page 53)

Operation Help
1. Set up your Kanguru iNAS 100:
Select the Kanguru iNAS 100 that you want to configure, and then click on
the Configure button. An authentication window asking you to enter the
administrator’s password appears as shown below:
Click on OK after entering the password. If the name and password are correct,
the configuration window is displayed on the screen:
er
our ISP.
rk
Change the LAN IP
address settings of
your Disk On-line
Server. If you are not
familiar with these
settings, please keep
them unchanged.
Setup the name, date and
time of this Disk On-line
Server. You can input any
name you want except
special characters.
Configure the DHCP
service to assign the
dynamic IP addresses
for your local
network.
If PPTP is used to
connect to the
Internet, enter the
PPTP server IP
Address, user name
and password from
the ISP or netwo
administrator
If PPPoE is used to
connect to the
Internet, enter the us
name and password
provided by y
When finished, click on “OK” to
confirm and exit. Click “Cancel” to exit and discard
changes.
Use a fixed IP address for
WAN port. You will need to
enter the IP address, subnet
mask and the gateway IP
address. Use DHCP protocol to obtain the WAN IP
address automatically. DHCP protocol is
commonly used in cable broadband service
or intranet.
Change the settings and click on OK when done to complete the configuration
setup.
Note:
1. After changing some settings, you may be asked to restart the Kanguru
iNAS 100 .
2. If you want to set up detailed configuration, you need to enter the
administration web page of the Kanguru iNAS 100 via the browser.
53