Kanguru Solutions iNAS-100 - Manual (Page 45)

Chapter 7
Kanguru iNAS 100 - Maintenance
The Kanguru iNAS 100 has been specially designed to run 24 hours a day, 7 days
a week and to be ready at all times. It robust to protects against system crashes
caused by power loss. This section provides a general maintenance overview.
Shutdown/Restart the Server
Please use the following steps to shutdown/restart the server:
1. Ask all the connected users to save their open files and stop using the
Kanguru iNAS 100.
2. Open the administration web page and go to System Tools ·
Restart/Shutdown. Follow the instructions to restart or shutdown the system.
Reset the Administrator Password & Network
Settings
If you accidentally forget the administrator password, you will not be able to perform
any administration work on the Kanguru iNAS 100. Under this condition, you can
reset the administrator password and network configuration to the factory default.
1. Use the tip of a ball point pen and depress the configuration reset switch
located on the back of the Kanguru iNAS 100. Hold it for about 5 seconds
until it beeps.
2. The network configuration will be reset, and you may need to re-configure
some or all of the network settings before you can connect to the Kanguru
iNAS 100.
3. Use a web browser to connect to the Kanguru iNAS 100. Enter the System
Administration and enter the following login name and password.
Login: Administrator
Password: admin
You can then perform system administration.
45