Error messages, Restoring the factory set data, Specifications – KORG Electribe EM-1 User Manual

Page 51: Er.1 er.2 er.9 full

Advertising
background image

7.Data

○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○

7.Data

51

Error messages

Data could not be written.

When writing a song to a song of a different

number, the maximum number of recordable
events was exceeded. Please erase event data
to free up memory (p.45).

Protect was turned "on" for the memory into
which you attempted to write data. In Global
mode, turn the Protect setting "oFF" (p.48).

When event-recording on a song, event data
memory has filled up. If you attempt to record
additional events, the "memory full" message
will appear immediately. Please erase event
data to free up memory (p.45).

Restoring the factory set

data

The pattern and song data with which the EM-1 is shipped
from the factory is referred to as the "preloaded data," and
you can restore this preloaded data back into the memory of
the EM-1.
When you do this, the patterns you created and the songs
which use these patterns will be erased, and replaced by the
preloaded data. If you wish to keep the patterns and songs
you created, you must save the data on a data filer etc. before
you load the preloaded data.

1. While simultaneously pressing the Transpose key and the

Write

key, turn on the power.

2. The display will indicate "

PLd

," and the Play/Pause key

will blink.

3. To load the factory preloaded data, press the blinking Play/

Pause key.

This will require apporoximately 30 seconds.
To cancel, press the Stop/Cancel key.

When loading is complete, the EM-1 will return to its initial
state. After several seconds the display will indicate pattern
number "

A.01

," and the EM-1 will be in Pattern mode.

Never turn off the power during the Load process. The
data may be damaged.

!



Specifications

Number of parts:

12 parts

Synth parts x 2
Drum parts x 8
Synth Accent part
Drum Accent part

Memory capacity:

256 patterns, 16 songs

Master effects:

Tempo Delay,

Normal, Motion Sequence

Insert effects:

11 Type

Reverb, Flanger/Chorus,Phaser, Ring
Modulator, Pitch Shifter, Compressor, Dis-
tortion, Decimator, Resonator, Filter,
Modulation Delay

Sequencer:

Pattern

Maximum 64 steps for each part,
Motion sequence,

Synth part: 3 parameters,
Drum part: 2 parameters,
Accent part: 1 parameter,
64 events

Song

Maximum 256 patterns per song
Maximum approximately 35,700 events
for event recording

Connectors:

PHONES

Stereo phone plug
Nominal level: 35 mW
Load impedance: 33 ohms

OUTPUT (L/MONO, R)

Phone jacks: mono x 2
Nominal output level: -10 dBu
Output impedance: 1 k-ohms

MIDI (IN, OUT, THRU)

Power supply:

DC 9 V (AC adapter included)

Power consumption:

5 W

Dimensions:

300 (W) x 222.5 (D) x 55.4 (H) mm
(with rubber feet)

Weight:

1.25 kg

* Specifications and appearance are subject to change with out

notice for improvement.

Er.1
Er.2

Er.9

Full

Advertising