KORG Electribe EM-1 - Manual (Page 7)

7
1. Introduction ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
1. Introduction
Make connections and play!
Example connections
Power switch
Adapter cable holder
AC Local Voltage
Preparing to play
Be sure to turn off the power before making connections. Careless operation may damage
your speaker system or cause malfunctions.
As shown in the above diagram, hook the AC adapter cable around the adapter cable holder.
When removing the cable from the holder, do not use excessive force.
1. Connect the included AC adapter to the DC 9V jack, and plug the adapter into an AC
outlet.
2. Connect one end of your audio cables to the line out jacks of the EM-1 (L/MONO, R), and
connect the other end to your mixer or powered monitor speakers (amplified speakers) etc.
If you will be listening in mono, use the L/MONO jack. To take full advantage of the EM-1's
sound quality, we recommend that you listen in stereo.
3. If you will be using headphones, connect them to the headphone jack.
The output from the line out jacks will not be switched off even if headphones are plugged in.
Master volume
Drum part keys
4. When you have finished making connections, turn on the power. Slightly raise the master
volume of the EM-1, and strike the Drum part keys (1...6B) to check whether connections
have been made correctly. Use the master volume of the EM-1 and the gain and fader con-
trols of your mixer or powered monitor system to adjust the volume to an appropriate
level.