Kyocera 1650 - Manual (Page 104)

Maintenance
5-8
11 (16/20 ppm model)
While holding gently the grid cleaner with your left
hand, pull out the electrical charge section as far as it
will go and push it back until the portion B does not
touch the white pad of the grid cleaner.
Repeat this operation several times.
(25 ppm model)
While holding gently the grid cleaner with your left
hand, pull out the electrical charge section as far as it
will go and push it back until the roller C does not touch
the white pad of the grid cleaner.
Repeat this operation several times.
Important! When pushing back the electrical charge section, do not push it all the way into the main body.
Copying trouble may occur.
12 When the electrical charge section is pulled out
approximately 5 cm (2 inches), remove the grid cleaner
and then push back the electrical charge section all the
way into the main body.
Important! After you use the grid cleaner to clean the electrical charge section, the machine can be used again
after more than 5 minutes have elapsed.
13 Hold the new toner container vertically and tap the
upper part five times or more.
Turn the toner container upside down and tap the upper
part five times or more.
14 Shake the toner container up and down five times or
more.
Turn the toner container upside down and shake it five
times or more.
B
C