Kyocera 1650 - Manual (Page 43)

Preparations
2-11
Connecting the Cables
This machine can be connected either to a network or directly to a single computer. This section
describes the procedures to make both types of connection.
Connecting the Network Cable
To connect this machine to a network, use an Ethernet cable (10Base-T or 100Base-TX).
1 Open the main power switch cover located on the right
side of the machine, turn the main power switch off
({), and remove the power cord from the outlet.
2 Connect the network cable to the network interface
connector at the right side of the machine.
3 Connect the other end of the network cable to your network device (hub).
4 Make network settings. (See page 2-15.)
Connecting the Printer Cable
To connect the machine directly to your computer, use either a parallel cable or a USB cable.
Important! Be sure to turn the main power switch of this machine off before connecting the printer cable.
1 Open the main power switch cover located on the right
side of the machine, turn the main power switch off
({), and remove the power cord from the outlet. Turn
the power of your computer off.