Kenwood TS-570D - Manual (Page 46)

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
40
10 MEMORY FEATURES
MEMORY RECALL AND SCROLL
There are two modes that allow you to retrieve
frequencies and associated data that you stored in a
memory channel: Memory Recall and Memory Scroll.
Memory Recall:
In this mode, the transceiver receives and transmits
using a frequency that you retrieve. You can
temporarily change the frequency and associated data
without overwriting the contents of the memory channel.
Memory Scroll:
Use this mode to check the contents of memory
channels without changing the current receive
frequency. In this mode, frequencies that you retrieve
are not used for receiving and transmitting.
■ Memory Recall
1 Press [M/V] to enter Memory Recall mode.
• The memory channel that was last selected
appears.
2 Turn the MULTI/CH control, or press Mic [UP] or
[DWN] to select a memory channel.
• Continuously holding down Mic [UP] or
[DWN] steps the transceiver through the
memory channels until the button is released.
• The memory channels that contain no data
are skipped.
• You cannot change memory channels while
transmitting.
3 To exit Memory Recall mode, press [M/V].
Note: Memory channels can also be changed while using the
TF-SET function.
■ Split-Frequency Channels
1 Press [A/B] to select VFO A or VFO B.
• “ t A” or “ t B” appears to show which VFO is
selected.
2 Select the frequency, mode, etc. to be stored.
• The frequency and mode selected here will be
used for transmitting.
3 Press [A/B] to select the other VFO.
4 Select the receive frequency and mode.
5 Press [SPLIT].
• “SPLIT” appears.
6 Press [M.IN] to enter Memory Scroll mode.
• To exit Memory Scroll mode and abort the
storage process, press [CLR].
7 Turn the MULTI/CH control, or press Mic [UP] or
[DWN] to select a memory channel.
• Entering a 2-digit number such as 05 using
the numeric keys can also be used to select a
channel.
8 Press [M.IN] again to store the data.
• The previous data stored in the channel is
overwritten.
Note: When subtone frequencies differ between TX and RX
while performing memory-VFO split operation, the subtone
frequency for RX will be stored in the memory channel.