Kenwood TS-570D - Manual (Page 47)

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
41
10 MEMORY FEATURES
■ Memory-VFO Split Operation
Under “SPECIALIZED COMMUNICATING”
{page 23}, you learned split-frequency operation
using two VFOs. Recalling a split-frequency channel
is another way to do split-frequency operation. If you
access Menu No. 07 and select ON, you can also
use a memory channel and a VFO together for this
operation, as follows:
• RX: Memory channel
TX: VFO A or VFO B
• RX: VFO A or VFO B
TX: Memory channel
To use a memory channel for receiving:
1 Press [A/B] to select the VFO that you will use
for transmitting.
• “ t A” or “ t B” appears to show which VFO is
selected.
2 Select the frequency for transmitting.
3 Recall a memory channel.
4 Press [SPLIT] to start split-frequency operation.
• If you selected VFO B in step 1, press
[SPLIT] once again.
5 Press [M/V] to quit split-frequency operation.
To use a memory channel for transmitting:
1 Recall a memory channel.
2 Press [M/V].
3 Press [A/B] to select the VFO that you will use
for receiving.
4 Select the frequency for receiving.
5 Press [SPLIT] to start split-frequency operation.
6 Press [SPLIT] again to use the memory channel
that you recalled in step 1.
7 Press [SPLIT] once again to quit split-frequency
operation.
■ Memory Scroll
1 Press [M.IN] to enter Memory Scroll mode.
• The memory channel that was last selected
appears.
2 Turn the MULTI/CH control, or press Mic [UP] or
[DWN] to step through the memory channels.
• Entering a 2-digit number such as 05 using
the numeric keys can also be used to change
channels.
3 To exit Memory Scroll mode, press [CLR].
• The transceiver re-displays the memory
channel or VFO frequency that was selected
before you activated Memory Scroll.
■ Temporary Frequency Changes
After retrieving frequencies and associated data in
Memory Recall mode, you can temporarily change
the data without overwriting the contents of the
memory channel.
1 Access Menu No. 08 and select ON.
• Skip this step when changing only the
associated data.
2 Recall a memory channel.
3 Change the frequencies and associated data.
• Use only the Tuning control to select a
frequency.
4 If necessary for future use, store the changed
data in another memory channel. Refer to
“Channel
➡ Channel Transfer” {page 42}.
Note: Memory channel data can also be changed while using
the TF-SET function.