Konica Minolta IP-411 - Manual (Page 24)

Printer Drivers 2-7
Printer Drivers
Tray Selection/Paper Selection
The system selects the paper size and paper tray in the manner specified below.
When Paper Size is Not Specified
?
When a print job does not specify paper size, the default paper size will be used.
When a Paper Tray is Specified
?
When the print job specifies a tray, one of the following occurs:
(a) If the requested tray contains paper, the printer will use the requested tray.
(b) If the requested tray contains no paper, the printer will NOT look for another
tray that may contain the requested paper size.
NOTE: Make sure the tray you specify is supplied with the desired paper type and size.
Auto Tray Selection Mode
?
If you request a paper size in the application screen, the printer will locate the paper source for
that paper size and print the job.
?
If a paper size you requested in the application screen cannot be located, the system will prompt
you with a message on the control panel to request another paper size. In the event you are
prompted to request another paper size, you may do one of the following:
(a) Load the desired paper size in the manual tray or in tray 1 and continue printing.
(b) Select another paper size and print.
(c) Abort the job.
Special Paper (OHP/Thin/Thick)
?
If there is no paper installed, or if the wrong size paper is installed, the system will prompt you to
install paper.