Kenwood KOS-A300 - Manual (Page 19)

English | 19
Operation of hands-free phoning
Before Use
• For details on the Bluetooth cell-phone with the
hands-free function, see <About the Cell-Phone>
(page 30).
• You need to register your cell-phone before using
it with this unit. For more details, see <Registering
Bluetooth device> (page 23).
• If you have registered two or more cell-phones,
you need to select one of them. For more details,
see <Selecting the Bluetooth device You Wish to
Connect> (page 25).
• To use the Phone Book, it must be downloaded to
this unit in advance. For details, see <Downloading
the Phone Book> (page 24).
• “BT” indicator is lit when a cell-phone is connected
to this unit.
Function of KCA-BT200 (Optional Accessory)
Receiving a call
Answering a Phone Call
Press the [ ] button.
When a vehicle audio source is playing, switch the
source to this unit (AUX).
⁄
• If a USB device is connected during a call the call will be
disconnected.
• The name of the calling party is displayed if it has already
been registered in the Phone Book.
Rejecting an Incoming Call
Press the [SRC] button or press the [ ] button.
During a call
Disconnecting a Call
Press the [SRC] button or press the [ ] button.
Switching to the Private Mode
Press the Control knob for at least 1 second.
Switches between Private talk (“PRIVATE”) and
Hands-free talk each time this button is pressed.
⁄
• Depending on the type of your cell-phone, switching
to the private talk mode may select the source that was
used before commencing the hands-free connection.
If this happens, the source cannot be switched back to
the hands-free talk mode by operating this unit. Operate
your cell-phone to return to the hands-free talk mode.
Call waiting
Answering Another Incoming Call with the
Current Call Suspended
1 Press the Control knob.
2 Turn the Control knob or push it towards up
or down. Select the “ANSWER” display.
3 Press the Control knob.
Answering another Incoming Call after
Terminating the Current Call
Press the [SRC] button.
Answering the Waiting Call after Terminating
the Current Call
Press the [SRC] button.
Switching between the Current Call and Waiting
Call
Press the Control knob.
Each pressing of this knob switches the calling
party.
Other functions
Clearing the Disconnection Message
Press the [SRC] button.
“HF Disconnect” disappears.