Kyocera Laser Printing ELP - Manual (Page 16)

Enhanced Laser Printing
User manual
Examples:
3 Jobs each with 5 pages, selection is made from page 2 to 3 and they are printed
on time as.
As single jobs: Then from job 1, 2 and 3 always page 2 and 3 are printed
As a copy or all in one job: Only page 2 and 3 from the first job is printed
3 Jobs with each 5 pages, selection is made from page 2 to 3 and they are printed
with copy factor 2 as.
As single jobs: Then from job 1, 2 and 3 always page 2 and 3 are printed, copy 1
and 2
As a copy job: Only page 2 and 3 from the first job is printed, two times
All as one job: Only page 2 and 3 from the first job is printed, one time
• With certain limitations described below, you can even staple the jobs. Therefor
the previouse ways of printing become a big role.
• You may enter the page numbers from and to for narrowing down the printed part
of the document, copy or even whole document.
Notes:
You are able to resend the jobs to any ELP activated queue, but if the jobs are
already as they have to be, you can send them to any queue. This is why PPAdmin
shows all printers for selection.
For convenience PPadmin offers the ability to staple the selected job/s. But as
indicated above there are some rules, and if they do not apply, please resend them
through an ELP process.
The stapling rules:
• Do not use a stapling command withing the archived jobs.
• Do not use out tray commands, as the pages may be be feed in the incorrect tray
• Currently only one staple command of the LaserJet 9000/9500 series printers
are implemented. If you need other model or brands supported, please let us
know, or use an ELP process to apply.
• The different printing methods do apply. Depending the selected mode, you
may staple every job, every copy or all jobs from all copies.
www.stethos.com - 16 -