Konica Minolta NC-6 - Manual (Page 24)

Assigning an IP Address 5
NC-6 5-3
Check with your network administrator to determine if there is a
DHCP server available on the network. (If there is, a special IP
address will be assigned by the AutoIP function. However, the
copier will not be able to communicate with other devices on the
network that have had ordinary IP addresses assigned to them.
For details about the AutoIP function, refer to “Product
Specifications” on page 9-1.) Always select “SPECIFY” when
there is no DHCP server available.
When “AUTO” is selected to assign the IP address, the IP address
may sometimes be changed automatically. If the IP address and
other settings are changed, you may not be able to print to a
specified printer on the network due to a communication failure
caused by a change in the address. When “AUTO” is selected, we
recommend that you set the DHCP server to assign a fixed
address to the copier.
5 Use the 10-key pad and
the
and keys to enter the IP
address.
✎
Note
If an IP address is already entered, it can be overwritten by a new
one.
The IP address shown in the illustration is only an example. Always
check with your network administrator before entering an IP
address for the printer.
6 Press the [Yes] key to confirm the setting. The “NETWORK SETTING”
menu appears again.
❍ Proceed to enter the subnet mask setting.
7 While the “NETWORK SETTING”
menu is displayed, press the [2] key
in the 10-key pad to select “SUB-
NET MASK”.