Konica Minolta FRS-1000 - Manual (Page 20)

20
Troubleshooting (Cont.)
Weak or no Weak batteries Charge or replace batteries
signal received Channel and privacy Adjust the transceiver’s
code not set the same settings to match those
as target transceiver settings of the target
transceiver
Volume level too low
Increase volume level
PTT Button inadvertently Release PTT Button
depressed
Excessive radio interference
Change to a different
on a particular channel channel
Obstruction of radio signal Avoid operating in or near
large buildings or vehicles
Unit beeps, but Batteries extremely Charge or replace batteries
will not function discharged
when turned on
Reception of CTCSS privacy mode Turn on the CTCSS privacy
unwanted signals not on mode and set code number to
match the setting of the
target transceiver.
Interference from Turn the devices off or move
electronic devices such farther away from them.
as computers or TVs
Charge light Batteries are not installed and Install Audiovox approved
flashes CHARGE switch (1) is on batteries
Problem Possible cause Correction