KORG MICROX X50 - Manual (Page 134)

127
EFFECT
When “(Sw)” = Mmnt (Moment), the speaker is rotating. It stops
only when you press the pedal.
Rotation will occur when the value of the modulation
source is less than 64, and will stop when the value is 64 or
greater.
b: (Sw)
This parameter sets how the rotation speed (slow and fast) is
switched via the modulation source.
When “(Sw)” = Tggl (Toggle), the speed is switched between
slow and fast each time you press the pedal.
Slow/fast will alternate each time the value of the modula-
tion source exceeds 64.
When “(Sw)” = Mmnt (Moment), the speed is usually slow. It
becomes fast only when you press the pedal.
When a value for the modulation source is less than 64,
“slow” speed is selected, and when the value is 64 or higher,
“fast” is selected.
c: ManuSp
If you wish to control the speaker rotation speed manually, not
switching between Slow and Fast, select the modulation source in
the “ManuSp” field. If manual control is not necessary, set this
field to Off.
d: Horn Accel, e: Rotor Accel
On a real rotary speaker, the rotation speed is accelerated or decel-
erated gradually after you switch the speed. The “Horn Accel”
parameter sets the speed at which the rotation is accelerated or
decelerated.
f: MicDistance, f: Spread
This is a simulation of stereo microphone settings.
ER/Delay
Early reflection and delay effects
41: Early Reflect
(Early Reflections)
This effect is only the early reflection part of a reverberation
sound, and adds presence to the sound. You can select one of
the four decay curves.
a: Type
This parameter selects the decay curve for the early reflection.
Mic Spread
Microphone Microphone
Mic Distance Mic Distance
Rotary Speaker (Top View)
Rotary Speaker - Mic Placement
a
Type Sharp, Loose, Modulated, Reverse
Selects the decay curve for the early reflection ☞
b
ER Time
Sets the time length of early reflection 10...800ms
c
Pre Delay 0...200ms
Sets the time taken from the original sound to the first early reflection
d
Pre EQ Trim 0...100
Sets the input level of EQ applied to the effect sound
e
LoEQ (Pre Low EQ Gain)
Sets the gain of Low EQ –15.0...+15.0dB
HiEQ (Pre High EQ Gain)
Sets the gain of High EQ –15.0...+15.0dB
f
W/D (Wet/Dly) Dry, 1:99...99:1, Wet
Sets the balance between the effect and dry sounds
(Source) Off...Tempo
Selects the modulation source of the effect balance
(Amount)
Sets the modulation amount of the effect balance –100...+100
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
EQ Trim
+
EQ Trim
Pre Delay Early Reflections
LEQ HEQ
Sharp
Loose
Modulated
Early Reflections - Type
Reverse
Dry Pre Delay ER Time