KORG MICROX X50 - Manual (Page 16)

9
PROG
0
1
2
3
4
5
6
7
8
9
Select by Category
Selects multisamples by category.
For the procedure, refer to “Select by Category” (
☞p.2).
This command is valid if “Mode (Oscillator Mode)” (1–
1a) is set to Single or Double, and you have selected
the 1–2b: High, Low parameter.
1–3: OSC2
This will appear when “Mode (Oscillator Mode)” (1–1a) is
set to Double.
For details on the settings and function of the parameter,
refer to “1–2: OSC1.”
1–4: V.Zone
(Velocity Zone)
Specifies the range of velocities that will sound oscillator 1
and 2. By using these settings in conjunction with the
“Velocity SW L
→H” (1–2a) setting of each oscillator, you can
specify the velocity ranges for the High and Low multisam-
ples or drum kits.
1–4a: OSC 1/2 Velocity Zone
OSC1 Bottom [001...127]
Sets the minimum velocity value that will sound oscillator 1.
OSC1 Top [001...127]
Sets the maximum velocity value that will sound oscillator
1.
OSC2 Bottom [001...127]
Sets the minimum velocity value that will sound oscillator 2.
OSC2 Top [001...127]
Sets the maximum velocity value that will sound oscillator
2.
It is not possible to set the Bottom Velocity greater than
the Top Velocity, nor the Top Velocity less than the Bot-
tom Velocity.
X50: You can also input a value by playing a note on the
keyboard while you hold down the [ENTER] button.
■ 1–4: UTILITY
☞“Write Program” (0–1), “Copy Oscillator,” “Swap Oscilla-
tor” (1–1)
1–5: Audition
When selecting preloaded programs, you can play back a
pre-specified riff (phrase) that is suitable for the sound of
that program. This is called the Audition function.
When you press the [AUDITION] button to turn it on, the
audition riff will play back repeatedly.
Here you can select the audition riff and specify the transpo-
sition.
1–5a: Audition Riff, Transpose
Audition Riff [000: Off...383: name]
Selects the audition riff. The X50/microX contains 383 audi-
tion riffs suitable for a variety of instruments and musical
genres.
With a setting of 000: Off, no riff will be played.
Transpose [–24...+24]
Adjusts the pitch of the audition riff in semitone steps.
It is not possible to change the playback tempo of the
audition riff. Nor is it possible to set the arpeggiator
tempo while the audition riff is playing.
The arpeggiator will be turned off while the audition
riff is playing.
■ 1–5: UTILITY
☞“Write Program” (0–1)
1–4a
1–5a