King Controls 9754 - Manual (Page 14)

Page 12
SECTION 4
SATELLITE CONFIGURATION
1. Unplug the controller and plug in the Diagnostic Keypad.
2. Press ON.
3. Press * 46 # to display the current satellite switching mode.
4. To change the satellite switching mode, press * 96 #
* 66 #
* 88 #
5. Press the UP and DOWN arrows (2 and 8 keys) to choose the desired switching mode.
6. Press * 47 # to lock in setting.
7. Turn unit OFF and back ON to save setting.
8. Press * 46 # to display code for new satellite switching mode.
The King-Dome In-Motion Satellite System with integrated DVB (models 9754 and 9754-LP) can
be configured to lock on a specific satellite, or auto switch between a pre-set pair of satellites.
The system is factory pre-set for basic DIRECTV service broadcast from the 101° W satellite.
To configure the dish for other services, you will need to change the satellite switching mode and
satellite service configuration as outlined below and on the next page.
16 DIRECTV Plus a. (satellites 101, 119)
b. (satellites 101, 110, 119 HDTV*)
26 DISH 500 (SW21 switch) (satellites 110, 119)
02 Single satellite mode (manual switching)
Switching Mode Satellite Service Satellites
SATELLITE SWITCHING MODE
You can change the operating mode to automatically switch between satellites 110/119 for Dish
Network, and 101/110/119 for DIRECTV as follows:
Note: Satellite re-configuration requires a King Controls Diagnostic Keypad #1844 not supplied with the antenna.
To configure your antenna for a different service, contact your local authorized King-Dome dealer or
call King Controls at (800) 982-9920.
* Note: Requires optional HD converter accessory purchased separately.
1844
Diagnostic Keypad