King Controls 9754 - Manual (Page 16)

Page 14
SECTION 5
STATIONARY OPERATION
Note: If you are using the automatic satellite switching feature, you must leave the King-Dome on.
IMPORTANT: There must be a clear “line of sight” to the southern sky. Mountains, buildings, trees,
telephone poles, etc. can all block the satellite signal from reaching the dish.
The distance driven since last performing a search may affect how long it takes for the
King-Dome to find the satellite.
Satellite TV and receiver technology are constantly changing. If you experience difficulty
go to www.kingcontrols.com or contact the King Controls Service Department at
(800) 982-9920, ext. 373.
1. Turn on TV and Receiver. “Searching for Satellite” or similar will appear on TV screen.
2. On King Dome controller, press and hold
ON/SEARCH for 3 FULL SECONDS.
Power light turns steady GREEN.
3. If the status light is steady GREEN, and your programming does not appear, press the
reset button on your DIRECTV receiver. If using Dish Network, hold the receiver power
button in for 10 seconds to reset your receiver. Consult your receiver owner’s manual for
further details.
4. When receiver reset is complete, select a channel or the program guide to view your
programming. Turn off the King-Dome and enjoy.
flashes a variety of colors
for about 30 seconds
RED-flashing
GREEN-flashing (may start
flashing RED again)
GREEN-steady
unit performs self-diagnostic
search in progress
potential satellite found
satellite(s) found and search is complete
STATUS LIGHT SYSTEM STATUS