King Controls 9754 - Manual (Page 9)

Page 7
s
5. Place dome unit on installation location chosen using the criteria discussed in the
previous section. Shipping restraints must be removed, plugs must be inserted in holes
(Fig. 5, Page 5), and cable connections must be positioned facing rear of vehicle.
6. The dome unit must be positioned so that both feet on each side of the vehicle are equal
distances from the roof edge. This should be checked by measuring the distance from
each foot to the roof edge. Confirm that these measurements are equal (Fig. 8).
IMPORTANT! Make sure shipping restraints are removed from bottom of dome unit and
plugs are inserted in holes (Fig. 5, Page 5).
Cable connections must ALWAYS be positioned facing the rear of vehicle.
Example of truck installation using bracket.
See bracket instructions for proper installation.
Fig. 8
Fig. 7
IMPORTANT! The dome unit MUST be mounted to the air ride cab: NEVER to any structure
mounted directly to the frame.
DOME INSTALLATION
IMPORTANT! The dome should never be mounted so that it is tilted more than
two degrees in any direction.
IMPORTANT!
Cable connections
must always face
REAR of vehicle.