King Controls 9754 - Manual (Page 6)

KIT CONTENTS:
1. Unpack and identify all components (Fig. 4).
Page 4
SECTION 3
INSTALLATION
Fig. 4
TOOLS AND MATERIALS REQUIRED:
- drill and drill bit set
- tape measure
- 7/16” open end wrench (coax connections)
- adhesive sealant (compatible with roof material)
- appropriate fasteners to install all components and wiring
- 5/32” allen wrench, channel lock or pliers (to remove shipping bolts)
- wire cutter (to remove shipping tie strap)
- #1844 King Controls Installation and Diagnostic Keypad
KIT CONTENTS
King-D Dome
In-Motion System w/DVB
STATIONARY OPERATION
1. Turn TV and satellite receiver ON.
2. Press and hold ON/SEARCH button for 3 FULL SECONDS.
Expect Status Light
RED -flashing . . . . . . .Searching
GREEN - flashing . . . .potential satellite found
GREEN - steady . . . . .Search Complete
Note: If the status light flashes orange after completing the
search process, there is something likely blocking the
satellite signal from reaching the antenna (tees,
buildings, etc).
2. If the search is complete and your programming does not
appear, press the reset button on your DIRECTV receiver. If
using Dish Network, hold the receiver power button in for 10
seconds to reset the receiver.
2. Select your desired channel and enjoy.
Note: To use the automatic satellite switching feature,
DO NOT turn the King-Dome OFF!