Kenwood HC MGR-A7 - Manual (Page 51)

English 51
Notes on Disposal
Recycling the Built-in Battery
This unit uses a lithium ion rechargeable battery cell as the built-in battery. The lithium ion
rechargeable battery is a recyclable resource. When disposing of the Transmitter, take out
the built-in battery and bring it to your local recycling business.
WARNING
• Do not heat excessively the built-in battery, open it, modify it or throw it in fire or
water.
Excessive heat generation, explosion or fire ignition may cause a fire.
• Do not leave the built-in battery near fire or under direct sunlight.
A fire, explosion or excessive heat generation may result.
• Attach insulating tape on the connectors of the built-in battery.
A fire or explosion may result if the battery electrodes are short-circuited.
• Do not leave the built-in battery within the reach of children.
Injury or other accidents may result.
• If the built-in battery fluid leaks and enters your eyes, immediately rinse your eyes
with fresh water and call a doctor.
If the fluid is left in your eyes, an eye injury may result.
Removing the Rechargeable Battery (Built-in Battery) Before Disposal
IMPORTANT:
Never attempt to open this unit besides when disposing of it.
For replacement of the built-in battery, contact your nearest Kenwood service agent.
• Remove the built-in battery after having confirmed that it is completely discharged.
• Once the built-in battery is disconnected, do not attempt to reconnect it to the connector on
the circuit board.
• Bring the removed built-in battery to a rechargeable battery recycling business as early as
possible.
1 Open the SD card cover.
2 Remove the 2 screws from the panel
using a precision Phillips screwdriver
(+).
3 Slide and remove the front case of
this unit.
4 Disconnect the built-in battery
connector and 3 microphone
connectors.
5 Using a precision screwdriver (+),
remove the 3 screws and remove the
circuit board.
6 Using the precision screwdriver (+),
remove 2 screws and remove the built-
in battery mount.
7 Take out the built-in battery.
8 Attach a piece of insulating tape on
the connector at the end of the cable
from the built-in battery, and put it in a
plastic bag, etc.