Kathrein MSK 24 - Manual (Page 24)

Sat measurement
24
LNB Voltage and 22 kHz / 60 Hz Switch-Over
The LNB supply voltage is available at the RF socket. This is confirmed
by the LED next to the RF socket which lights up when the voltage supply
is switched on. The current consumed by the connected LNB is indicated
in the LC display.
The 22 kHz or 60 Hz square wave signal that can be added is
superimposed on the LNB voltage. It is needed to switch multifeed
systems or high/lowband LNBs.
The LNB voltage can be
•
switched off = 0V
•
set from 10 V to 20 V in steps of 0.1 V
•
short-circuit protected (max. current 500 mA)
The following voltages can be called up by pressing the relevant button:
LNB voltage Button
0V [0]
12V [1]
14V [2]
18V [3]
Overview of commands in LNB Voltage
[2ndF] [LNB] Call up the LNB menu
[0]...[3] Select the LNB voltage
[-] or [+] Change the LNB voltage in 0.1 V steps
[7] 60 Hz signal on/off
[8] 22 kHz signal on/off
Exit the LNB menu by pressing [2ndF] twice.
Example
Call up the LNB voltage 14 V:
Press buttons [2ndF] [LNB] [2]
LC display:
•
LNB voltage: 14 V
•
Current consumption: 150 mA
Note
By pressing the [+] or [-] buttons you can change the LNB voltage in
steps of 0.1 V.
By calling up another function, e.g. [2ndF] [CH-FRQ], you can exit the
LNB menu automatically.
LNB:14,0V
150mA
0
л
+