Kathrein MSK 24 - Manual (Page 36)

TV measurement
36
Frequency Display and Entering Frequency
To measure the level of a received TV signal, you must first enter the
desired video carrier frequency.
You can enter the frequency in steps of 50 kHz from 45 MHz to 867 MHz.
Overview of commands in Entering Frequency (TV)
[SAT/TV] Switch over to TV reception
[CH-FRQ] Switch-over between channel and frequency
[0]...[9] Enter frequency
[ENTER] Confirm entry
[+] and [-] Change frequency gradually
Example
Enter frequency of 175.25 MHz:
Press [2ndF] [CH/FRQ] ................... ..(Call up the frequency menus)
Then [1] [7] [5] [./S] [2] [5] [ENTER] .. .(Entering frequency)
LC display:
•
Frequency: 175.25 MHz
•
Level: 65.0 dBìV
•
Mode: TV
Note
Once you have called up the frequency menu, you only need to enter the
figures to enter the frequency again.
The last frequency setting is retained even when the MSK 24 is switched
off provided it was made using "numerical entries" and concluded with
"MHz".
0
+
ë
CH:175,25 TV
LEV: 65,0dBuV