Kenwood KR-V888D - Manual (Page 18)

1 8
Operations
KR-V888D (En/T)
1
Turn on the receiver.
Keys or controls used in this operation.
Listening to a source component
A ON : Sound from the speakers connected to the SPEAK-
ERS A terminals on the rear panel.
B ON : Sound from the speakers connected to the SPEAK-
ERS B terminals on the rear panel.
A+B ON : Sound from both the speakers connected to the
SPEAKERS A and B terminals on the rear panel.
A+B OFF : No sound from the speakers. Use this setting when
listening with headphones for stereo sound in all
playback modes.
• When both SPEAKERS A and B are ON, activating a surround mode
turns SPEAKERS B OFF automatically.
2
3
The indicator for the speakers you want to use should be lit.
5
4
Decrease volume Increase volume
Select a speaker system.
Select the source you desire.
Adjust the volume.
Start playback from the selected source.
Preparations ÷
Turn on the power to the related compo-
nents.
÷
Set the POWER key to the ON position.
Normal playback
A SP.
PHONO
B
A B
AUDIO
SHIFT MACRO
TV VIDEO
GUIDE REC
MUTE
VOLUME TUNING/SKIP
THEME FAV MENU
FUNCTION SHIFT SETUP
INFO ALT AUD TV/SAT/VID
REPEAT RANDOM +100
DISPLAY
ENT +10
LISTEN MODE SOUND SUBWOOFER
5 6 4
2 3 1
8 9 7
0
8
7
4 ¢ 6 BAND
P. CALL P. CALL
PHONES
1 2 3 4 5 6 7 8 9 0
STANDBY 2-CH DOWNMIX LEVEL INDICATOR
DIRECT MEMORY A B SPEAKERS AUTO MUTE TUNING BASS TREBLE BAND LEVEL CONTROL
DOLBY
DIGITAL PRO LOGIC
3 STEREO STEREO
SOURCE DIRECT DSP
DIMMER
INPUT SELECTOR VOLUME CONTROL
VIDEO
ON/STANDBY
DOWN UP
L - AUDIO - R
LOUDNESS TA/NEWS/INFO. PTY DISPLAY +10/ PTY SEARCH
POWER
-ON –OFF
AV AUX
AUDIO − VIDEO SURROUND RECEIVER KR-V888D
T R A I T R
thermally reactive advanced instantaneous transistor
POWER
POWER
-ON –OFF
ON/STANDBY
SPEAKERS A B
INPUT SELECTOR
VOLUME CONTROL
DOWN UP
The input sources change as shown below:
* Once setup codes are registered in the remote control, the input name
display changes according to the name of the registered component.
Example: if you register a VCR at the VIDEO 1 jacks, "VCR1" appears
instead of "VIDEO 1".
°
• Both the default input name and the component type (i.e., " VIDEO1
'VCR1' ") are shown in the on screen display when the OSD mode is
set to ON.
fl
• When using the remote control after initial setup, any inputs that have
not been registered with a setup code are deleted from the cyclic list
(except for the "AV AUX" VIDEO input).
‚
• The INPUT SELECTOR on the front panel of the receiver always cycles
through all inputs.
1 TUNER (Frequency display)
2
"PHONO"("PHONO"*)
3 "VIDEO1" ("SAT"*)
4 "VIDEO2" ("LD"*)
5 "VIDEO3" ("VCR"*)
6 "AV AUX"
7 "CD" ("CD"*)
8 "TAPE/MD" ("TAPE"*)