Kenwood KR-V888D - Manual (Page 45)

4 5
KR-V888D (En/T)
Remote Control
Setup code correlation
Getting the most from your remote control
AUDIO
SHIFT MACRO
TV VIDEO
GUIDE REC
MUTE
VOLUME TUNING/SKIP
THEME FAV MENU
FUNCTION SHIFT SETUP
INFO ALT AUD TV/SAT/VID
REPEAT RANDOM +100
DISPLAY
ENT +10
LISTEN MODE SOUND SUBWOOFER
5 6 4
2 3 1
8 9 7
0
8
7
4 ¢ 6 BAND
P. CALL P. CALL
POWER
Keys or controls used in this operation.
1 Hold down the ENT key until the backlight flashes twice.
2 Select the component to be deleted.
Press the VIDEO, AUDIO, or TV key repeatedly to select the
desired component.
3 Enter the 3 digit code "991".
4 Hold down the ENT key until the backlight flashes twice.
Deleting a setup code
• At this time all inputs become available regardless of any earlier
registration.
• Example 1 : To delete the registration of the component connected to
the VIDEO 1 jacks, select "VIDEO 1".
Perform each step within 5 seconds.
• To resume the factory settings, proceed step 1, then enter “981”.
1 Hold down the ENT key until the backlight flashes twice.
2 Select the component with setup code you want to check.
Press the VIDEO, AUDIO, or TV key repeatedly to select the
desired component.
3 Enter the 3 digit code "990".
4 Press the 1 key and count the number of times the backlight
blinks. This is the first number of the 4 digit setup code.
5 Press the 2 key and count the number of times the backlight
blinks. This is the second number of the 4 digit setup code.
6 Press the 3 key and count the number of times the backlight
blinks. This is the third number of the 4 digit setup code.
7 Press the 4 key and count the number of times the backlight
blinks. This is the fourth number of the 4 digit setup code.
Checking a setup code
• The backlight flashes twice immediately after the "0" is input to confirm
input.
• If the backlight does not blink, the first digit in the setup code is 0.
• If the backlight does not blink, the second digit in the setup code is 0.
• If the backlight does not blink, the third digit in the setup code is 0.
• If the backlight does not blink, the fourth digit in the setup code is 0.
Perform each step within 5 seconds.