Kenwood VR-606 VR-616 - Manual (Page 10)

10 EN
S VIDEO
VIDEO 2 IN DVD IN MONITOR OUT
SUB WOOFER PRE OUT
VIDEO 2
COAXIAL
DVD
DIGITAL IN
CD / DVD
OPTICAL
VOLTAGE
SELECTOR
AC110V-120V / 220V-240V~
50 / 60Hz SWITCHED TOTAL 90W MAX.
AC OUTLETS
AC 220-
240V~
AC 110-
120V~
SPEAKERS
SURROUND
SPEAKERS
(8-16 Ω)
CENTER SPEAKER (8-16 Ω)
FRONT SPEAKERS (8-16 Ω)
GRAY WHITE GREEN BLUE RED
L C R L R
CENTER
SUB WOOFER SURROUND FRONT
DVD / 6CH INPUT
PLAY IN
VIDEO 2
AUDIO
REC OUT PLAY IN VIDEO1 PHONO REC OUT PLAY IN MD / TAPE CD / DVD
L
R
VIDEO 1 OUT VIDEO 1 IN
VIDEO
VIDEO 2
IN
DVD
IN
MONITOR
OUT
ANTENNA
GND
AM FM 75 Ω
SYSTEM
CONTROL
+
-
+
-
VIDEO 2
COAXIAL
DVD / 6CH
DIGITAL IN
CD / DVD
OPTICAL
Setting up the system
Digital connections
The digital in jacks can accept DTS, Dolby Digital, or PCM signals. Connect components capable of outputting DTS, Dolby Digital, or standard PCM (CD)
format digital signals.
If you have connected any digital components to the receiver, be sure to read the “Input mode settings” section carefully.
7
Component with DTS,
Dolby Digital, or PCM
COAXIAL DIGITAL OUT
COAXIAL
DIGITAL
OUT
(AUDIO)
DOLBY DIGITAL RF
OUT (AUDIO)
LD player
PCM OUT
RF digital
demodulator
(DEM-9991D)
(sold separately)
CD or DVD player
OPTICAL DIGITAL OUT (AUDIO)
Optical fiber cable
COAXIAL DIGITAL OUT
(AUDIO)
Connect the video signal and analog
audio signals to the VIDEO 2 jacks.
(See “Connecting video components”.)
9
To connect an LD player with a DIGITAL RF OUT, connect the LD player to the KENWOOD RF digital demodulator (DEM-9991D).
Next, connect the DIGITAL OUT jacks of the demodulator to the DIGITAL IN jacks of the receiver.
Connect the video signal and analog audio signals to the VIDEO 2 jacks. (See “Connecting video components”.)
*5228/07-14/EN 14/06/2002, 11:54 AM 10