Kenwood VR-606 VR-616 - Manual (Page 20)

20 EN
Listening to radio broadcasts
The receiver can store up to 40 stations in the memory and recall them
by one-touch operation.
Tuning radio stations
1
Use the INPUT SELECTOR knob or TUNER key to select the
tuner.
2
Use the BAND key to select the desired broadcast band.
Each press switches the band
as follows:
1 FM
2 AM
3
Use the AUTO key to select the desired tuning method.
Each press switches the tuning method as follows:
1 AUTO lit (auto tuning)
2 AUTO not lit (manual tuning)
• Normally, set to “AUTO” (auto tuning). If the radio waves are weak
and there is a lot of interference, switch to manual tuning. (With
manual tuning, stereo broadcasts will be received in monaural.)
4
Use the MULTI CONTROL knob or Joystick, or TUNING 1
/ ¡ keys to select the station.
Auto tuning : The next station is tuned automatically.
Manual tuning : Turn the knob (press the key) to select the
desired station.
Presetting radio stations manually
MULTI CONTROL
MEMORY
1
Tune to the station you want to store.
2
Press the MEMORY key while receiving the station.
3
Use the MULTI CONTROL knob to select one of the station
presets (1 – 40).
4
Press the MEMORY key again to confirm the setting.
• Repeat steps 1, 2, 3, and 4 to store as many stations as
necessary.
• If you store a station at a previously used preset, the previous station
will be replaced by the new one.
“AM” or “FM” indicator
appears in the display
“AUTO” indicator lights
up in the display.
Frequency
display
“TUNED” is displayed
when a station is received.
“ST.” lights when
a broadcast is being
received in stereo.
Proceed to step 3 within 5 seconds.
(If more than 5 seconds elapse, press the MEMORY key again).
Blinks for 5 seconds Lights for 5 seconds
MULTI CONTROL
INPUT SELECTOR BAND AUTO
TUNER
AUTO
BAND TUNING 1 / ¡
Joystick
(MULTI
CONTROL 5/∞)
*5228/19-21/EN 14/06/2002, 11:59 AM 20