Kenwood VR-606 VR-616 - Manual (Page 5)

5 EN
STANDBY
DIMMER
PHONES CINEMA EQ
LISTEN MODE
INPUT MODE BAND AUTO MEMORY
DSP DTS DOLBY DIGITAL
SOUND
SET UP
MULTI CONTROL INPUT SELECTOR
DOWN
MUTE
UP
VOLUME CONTROL
POWER
SPEAKERS ON ⁄ OFF
ON ⁄ STANDBY
Names and functions of parts
1 POWER ON/STANDBY key %
Use to turn the power ON/STANDBY.
STANDBY indicator
2 DIMMER key
Use to select the REC MODE. (
Use to adjust the brightness of the display.
¶
3 LISTEN MODE key ¢
Use to select the listening mode.
4 Surround indicators
DSP mode indicator ¢
Lights when the receiver is in the DSP mode.
DTS mode indicator
¢
Lights when the receiver is in the DTS mode.
DOLBY DIGITAL indicator
¢
Lights when the receiver is in the Dolby
Digital mode.
5 SOUND key ∞
Use to adjust the sound quality and the
ambience effects.
6 MULTI CONTROL knob %
Use to control a variety of settings.
7 INPUT SELECTOR knob &
Use to select the input sources.
8 VOLUME CONTROL knob &
9 PHONES jack *
Use for headphone listening.
0 SPEAKERS ON/OFF keys &
Use to turn the speakers ON/OFF.
! CINEMA EQ key *
Use to switch the status of CINEMA EQ.
@ INPUT MODE key 7
Use to switch between full auto, digital and
analog inputs.
# BAND key )
Use to select the broadcast band.
$ AUTO key
Use to change “TAPE” indication to “MD”.
&
Use to select the auto tuning mode. )
% MEMORY key )
Use to store radio stations in the preset
memory.
^ SET UP key %
Use to select the speakers' settings etc.
& MUTE key *
Use to temporarily mute the sound.
Main Unit
Display
Speaker selection indicators
Input channel indicators
Output channel indicators
Band indicators
STEREO indicator
Frequency display,
Input display,
Preset channel display,
Surround mode display
Speaker indicator
PRO LOGIC
indicator
AUTO DETECT
indicator
DOLBY DIGITAL
indicator
DTS indicator
CLIP indicator
AUTO indicator
MEMO. indicator
ST. indicator
TUNED indicator
MUTE indicator
TONE indicator
LOUDNESS indicator
96kHzfs indicator
DSP indicator
DIGITAL indicator
CINEMA EQ. indicator
6CH INPUT indicator
Standby mode
While the standby indicator is lit, a small amount of power is supplied to the system to back-up the memory. This is called standby mode. Under the
condition, the system can be turned ON by the remote control unit.
*5228/01-06/EN 14/06/2002, 11:53 AM 5