Kenwood VR-606 VR-616 - Manual (Page 13)

13 EN
1 Strip coating. 2 Push the lever.
3 Insert the cord. 4 Return the lever.
Setting up the system
Connecting the terminals
Speaker impedance
After confirming the speaker impedance indications printed on the
rear panel of the receiver, connect speakers with matching impedance
ratings. Using speakers with a rated impedance other than that
indicated on the rear panel of the receiver could result in malfunctions
or damage to the speakers or receiver.
• Never short circuit the + and – speaker cords.
• If the left and right speakers are connected inversely or the speaker
cords are connected with reversed polarity, the sound will be
unnatural with ambiguous acoustic imaging. Be sure to connect the
speakers correctly.
Connecting the antennas
AM loop antenna
The supplied loop antenna is for use indoors. Place it as far as possible
from the receiver, TV set, speaker cords and power cord, and adjust
the direction for best reception.
FM indoor antenna
The supplied indoor antenna is for temporary use only. For stable
signal reception we recommend using an outdoor antenna. Disconnect
the indoor antenna when you connect one outdoors.
FM outdoor antenna
Lead the 75 Ω coaxial cable connected to the FM outdoor antenna into
the room and connect it to the FM 75 Ω terminal.
Use an antenna
adaptor
(Commercially
available)
Attach to the stand
AM loop antenna
FM indoor antenna
FM outdoor antenna
Speaker placement
Front speakers : Place to the front left and right of the listening
position. Front speakers are required for all surround modes.
Center speaker : Place front and center. This speaker stabilizes the
sound image and helps recreate sound motion. Required for surround
playback.
Surround speakers : Place to the direct left and right, or slightly
behind, the listening position at even heights, approximately 1 meter
above the ears of the listeners. These speakers recreate sound
motion and atmosphere. Required for surround playback.
Subwoofer : Reproduces powerful deep bass sounds.
• Although the ideal surround system consists of all the speakers
listed above, if you don't have a center speaker or a subwoofer, you
can divide those signals between the available speakers in the
speaker settings steps to obtain the best possible surround
reproduction from the speakers you have available.
%
Front
speaker
Subwoofer
Surround
speaker
Center speaker
Listening
position
AM antenna terminal connections
1 Push lever. 2 Insert cord. 3 Release lever.
FM antenna terminal connections
Insert cord.
S VIDEO
VIDEO 2 IN DVD IN MONITOR OUT
SUB WOOFER PRE OUT
VIDEO 2
COAXIAL
DVD
DIGITAL IN
CD / DVD
OPTICAL
VOLTAGE
SELECTOR
AC110V-120V / 220V-240V~
50 / 60Hz SWITCHED TOTAL 90W MAX.
AC OUTLETS
AC 220-
240V~
AC 110-
120V~
SPEAKERS
SURROUND
SPEAKERS
(8-16 Ω)
CENTER SPEAKER (8-16 Ω)
FRONT SPEAKERS (8-16 Ω)
GRAY WHITE GREEN BLUE RED
L C R L R
CENTER
SUB WOOFER SURROUND FRONT
DVD / 6CH INPUT
PLAY IN
VIDEO 2
AUDIO
REC OUT PLAY IN VIDEO1 PHONO REC OUT PLAY IN MD / TAPE CD / DVD
L
R
VIDEO 1 OUT VIDEO 1 IN
VIDEO
VIDEO 2
IN
DVD
IN
MONITOR
OUT
ANTENNA
GND
AM FM 75 Ω
SYSTEM
CONTROL
+
-
+
-
ANTENNA
GND
AM
FM
75 Ω
*5228/07-14/EN 14/06/2002, 11:54 AM 13