KORG Personal Multi-Effect Processor PX5D - Manual (Page 15)

15
Initial Settings
1
When you finish making connections, set the power
switch to the “ON” position. (This setting is referred
to as Play mode.)
Use the π/† CURSOR to select a program.
2
Set the input level switch depending on the output
level of your guitar or bass.
HI:
High-output pickups (e.g., humbucking or pick-
ups with a preamp)
LO:
Low-output pickups (e.g., single-coil type pick-
ups)
3
Set the volume control of your guitar or bass to its
usual position. Use the Value encoder to adjust the
master level.
Quick Edit
In each mode (except when Mute/Bypass or Key Lock
are active), you can use the Control dials to adjust the
gain, tone, or volume of amp modeling. When you move
a control dial, the parameter name and value will appear
for several seconds in the value display. If the setting
matches the original setting, the ORIG icon will light.
The Delay Time can also be set by pressing the TAP/BY-
PASS button
twice at the desired interval (except when
in Rhythm & Bass mode).
When you set the delay time, the value display will in-
dicate the delay time for several seconds.
Program
selection
Program
name
Input level switch Amp gain, tone, and volume
Program
number
Set the
delay time
Master level
adjustment
Settings that you make using Quick Edit will return to
the original saved settings if you change programs or turn
off the power before Writing (
☞p.31 “WRITE”).