Krell Industries S-1000 - Manual (Page 12)

Front Panel and Remote Control Description
See Figures 1 and 2 on page 7
8 Krell S–1000
The S–1000 Surround Preamp/processor front panel and remote
control access power on and off; input, and processing mode selec-
tion; monitoring and display of processor status; and balance and
volume control. For functions accessed only using the remote con-
trol, see page 12.
1 Power Button/Pre Key
The power button or pre key switches the S–1000 from stand-
by to the operational mode.
2 Power/Stand-by LED
Stand-by Mode. When the AC power cord is plugged into the
wall, and the back panel power switch (58) is on, the LED illu-
minates in red, indicating that the component is in the stand-
by mode.
Operational Mode. When the power button or pre key (1) is
pressed, the LED illuminates in blue, indicating that the com-
ponent is in the operational mode.
3 Infrared Sensor
The infrared sensor receives commands from the S–1000
remote control. For proper remote control operation, make sure
the infrared sensor is not covered or obstructed.
4 Infrared Emitter
Emits the S–1000 remote operation code to a learning remote.
See Program Remote, on page 51.
The S–1000 is equipped with ten input device selection buttons. If
properly configured, the S–1000 automatically engages the correct
video and audio inputs when you press the device selection button.
5 DVD Button/Key
Press this button or key to select the digital video disc device.
6 Cable Button/LD Key
Press this button or key to select the laser disc device.
7 SAT Button/Key
Press this button or key to select the satellite feed device.
8 VCR Button/Key
Press this button or key to select the VCR device.
Basic Functions
FUNCTIONS
Button = on front panel
Key = on remote control
Blue LED illuminated = function
active, except for power/stand-by
LED which illuminates red when
in stand-by mode.
Input Device Selection