Krell Industries S-1000 - Manual (Page 22)

Back Panel Description, continued
18 Krell S–1000
53 HDMI™ Inputs
The S –1000 is equipped with four HDMI™ video inputs.
The S–1000 switches HDMI™ video only. Audio signal is not available via
the HDMI™ inputs. On screen display (OSD) is not available from the
HDMI™ output. When an HDMI™ input is assigned to a device, and the
menu key on the remote is pressed, the on screen menu is available
simultaneously from composite, S-video, and component OSD outputs.
54 Comm Port RS-232 Connector
The S–1000 is equipped with an RS-232 communication port,
which sends operational instructions directly to the S–1000
using an external computer control system.
55 RC-5 In
The RC-5 input makes custom installation easy and secure by
accepting baseband RC-5 input commands from hardwired
remote controllers.
56 12 VDC In and Out
The S–1000 is equipped with four programmable 12 V outputs
and one input. Each trigger sends a 12 V power on/off signal via a
12 V trigger cable to other Krell components and to other devices
that incorporate 12 V power on/off trigger input. Trigger 1 is
enabled for all 10 devices.
When the S–1000 is in the operational mode and a trigger is enabled, the
12 VDC Out provides 12 V of DC output. When the S–1000 is in the
stand-by mode or off, or if a trigger is not enabled, the DC output is 0 V.
57 DB 25 Out
The S–1000 is equipped with a multi-channel audio output via a
DB-25 connector. The DB-25 contains the output connections
for all the output channels (left, center, right, subwoofer, surround
left, surround right, back left, and back right).
58 Back Panel Power Switch
Use this switch to change the S–1000 from off to stand-by.
59 IEC Connector
The S–1000 is equipped with a standard female IEC power con-
nector, for use with the AC power cord.
Back Panel Remote
Control Connections
Note
Note
Power Connections