Lexmark X6100 - Manual (Page 93)

89
Notices
Federal
Communications
Commission (FCC)
compliance information
statement
This equipment complies
with Part 68 of the FCC rules
and the requirements
adopted by the America’s
Carriers Telecommunication
Association (ACTA). On the
back of this equipment is a
label that contains, among
other information, a product
identifier in the format
US:AAAEQ##TXXXX. If
requested, this number must
be provided to your
telephone company.
This equipment uses the
RJ-11C Universal Service
Order Code (USOC) jack.
A plug and jack used to
connect this equipment to
the premises’ wiring and
telephone network must
comply with the applicable
FCC Part 68 rules and
requirements adopted by the
ACTA. A compliant telephone
cord and modular plug is
provided with this product. It
is designed to be connected
to a compatible modular jack
that is also compliant. See
page 3
for more information.
The Ringer Equivalence
Number (REN) is used to
determine the number of
devices that may be
connected to a telephone
line. Excessive RENs on a
telephone line may result in
the devices not ringing in
response to an incoming call.
In most but not all areas, the
sum of RENs should not
exceed five (5.0). To be
certain of the number of
devices that may be
connected to a line, as
determined by the total
RENs, contact your local
telephone company. For
products approved after July
23, 2001, the REN for this
product is part of the product
identifier that has the format
US:AAAEQ##TXXXX. The
digits represented by ## are
the REN without a decimal
point (e.g., 03 is a REN of
0.3). For earlier products, the
REN is separately shown on
the label.
If this equipment causes
harm to the telephone
network, the telephone
company will notify you in
advance that temporary
discontinuance of service
may be required. If advance
notice is not practical, the
Telephone Company will
notify the customer as soon
as possible. You will also be
advised of your right to file a
complaint with the FCC.
The telephone company may
make changes in its facilities,
equipment, operations or
procedures that could affect
the operation of this
equipment. If this happens
the telephone company will
provide advance notice in
order for you to make
necessary modifications to
maintain uninterrupted
service.
If trouble is experienced with
this equipment, for repair or
warranty information, please
contact Lexmark
International, Inc. at
www.lexmark.com. If the
equipment is causing harm
to the telephone network, the
telephone company may
request that you disconnect
the equipment until the
problem is resolved.
This equipment contains no
user serviceable parts. For
repair and warranty
information, please contact
Lexmark International, Inc.
See the previous paragraph
for contact information.
Connection to party line
service is subject to state
tariffs. Contact the state
public utility commission,
public service commission,
or corporation commission
for information.
If your home has specially
wired alarm equipment
connected to the telephone
line, ensure the installation of
this equipment does not
disable your alarm
equipment. If you have
questions about what will
disable alarm equipment,
consult your telephone
company or a qualified
installer.
Telephone companies report
that electrical surges,
typically lightning transients,
are very destructive to
customer terminal
equipment connected to AC
power sources. This has
been identified as a major
nationwide problem. It is
recommended that the
customer install an AC surge
arrestor in the AC outlet to
which this device is
connected. This is to avoid
damage to the equipment
caused by local lightning
strikes and other electrical
surges.
The Telephone Consumer
Protection Act of 1991 makes
it unlawful for any person to
use a computer or other
electronic device, including