Lantronix UDS2100 - Manual (Page 50)

7: Setup Mode: Channel Configuration
UDS2100 User Guide 50
Table 7-6. Modem Mode Commands
Modem Mode
Command Function
ATDTx.x.x.x,pppp
or
ATDTx.x.x.x/pppp
Makes a connection to an IP address (x.x.x.x) and a remote port
number (pppp).
ATDTx.x.x.x
Makes a connection to an IP address (x.x.x.x) and the remote
port number defined within the unit.
ATD0.0.0.0
Forces the unit into Monitor Mode if a remote IP address and
port number are defined within the unit.
ATD
Forces the unit into Monitor Mode if a remote IP address and
port number are not defined within the unit.
ATDx.x.x.x
Makes a connection to an IP address (x.x.x.x) and the remote
port number defined within the unit.
ATH Hangs up the connection (Entered as +++ATH ).
ATS0=n
Enables or disables connections from the network going to the
serial port.
n=0 disables the ability to make a connection from the network
to the serial port.
n=1-9 enables the ability to make a connection from the network
to the serial port.
n>1-9 is invalid.
ATEn
Enables or disables character echo and responses.
n=0 disables character echo and responses.
n=1 enables character echo and responses.
ATVn
Enables numeric response or full verbose.
n=0 enables numeric response.
n=1 enables full verbose.
Note: The unit recognizes these AT commands as single commands such as
ATE0 or ATV1; it does not recognize compound commands such as ATE0V.
Send the Escape Sequence (+++) in Modem Mode
Send ‘+++’ in Modem Mode (Y) ? _
Disable or enable the UDS2100’s ability to send the escape sequence. The default
setting is Y (Yes) (send the escape sequence).
Auto Increment Source Port
Auto increment source port (N) ? _
Y (Yes) auto increment the source port. The UDS2100 increments the port number
used with each new connection.