Network port, Reset button, Ethernet connector pinouts – Lantronix UDS2100 User Manual
Page 72: Power plug, Figure 12-3. network interface
12: Connections and Pinouts
UDS2100 User Guide
72
Network Port
The unit's back panel contains a 9-30VDC power plug and an RJ45 (10/100)
Ethernet port.
Figure 12-3. Network Interface
Reset Button
You can reset the unit to factory defaults, including clearing the network settings (IP
address, gateway, and netmask are set to 00s).
To reset the unit to factory defaults:
1. Place the end of a paper clip or similar object into the reset opening and press for
a minimum of 3 seconds.
2. Release the button and remove the paper clip. The firmware restores factory
default settings to the configuration and invokes a reset (internally).
Ethernet Connector Pinouts
Power Plug
Power input on the power plug is 9-30 VDC (center +)
(1.8W maximum power).
RJ45 Ethernet Port Reset Button
Power Plug