Lantronix UDS1100 - Manual (Page 46)

7: Setup Mode: Channel Configuration
UDS1100 User Guide 46
Figure 7-3. Manual Connection Address Example
Command String Result if remote IP is 129.1.2.3 and remote port is
1234
C121.2.4.5/1
Complete override; connection is started with host 121.2.4.5,
port 1.
C5 Connects to 129.1.2.5, port 1234.
C28.10/12 Connects to 129.1.28.10, port 12.
C0.0.0.0/0 Enters Monitor Mode.
Autostart (Automatic
Connection) If you enable Autostart, the unit automatically connects to the
remote IP address and remote port specified when the firmware
starts.
Hostlist If you enable this option, the device server scrolls through the
hostlist until it connects to a device listed in the hostlist table.
Once it connects, the unit stops trying to connect to any others. If
this connection fails, the unit continues to scroll through the table
until it is able to connect to another IP in the hostlist.
Hostlist supports a minimum of 1 and a maximum of 12 entries.
Each entry contains the IP address and the port number.
The hostlist is disabled for Manual and Modem Modes. The unit
does not accept a data connection from a remote device when
the hostlist option is enabled.
Figure 4-7. Hostlist Option