Lantronix UDS1100 - Manual (Page 48)

7: Setup Mode: Channel Configuration
UDS1100 User Guide 48
Data Echo & Modem
Response Full Verbose: The unit echoes modem commands and responds to
a command with a message string shown in the table below.
Numeric Response:
The unit echoes modem commands and
responds to a command with a numeric response.
Modem Responses
Only Full Verbose: The unit does not echo modem commands and
responds to a command with a message string shown in the table
below.
Numeric Response:
The unit does not echo modem commands
and responds to a command with a numeric response.
Table 4-11. Modem Mode Messages
Message Meaning
Full Verbose
OK Command was executed without error.
CONNECT A network connection has been established.
NO CARRIER A network connection has been closed.
RING n.n.n.n.
A remote device, having IP address n.n.n.n, is connecting to this
device.
Numeric Response
0 OK
1 Connected
2 Ring
3 No Carrier
4 Error
Received commands must begin with the two-character sequence AT and be
terminated with a carriage return character.
The unit ignores any character sequence received not starting with AT, and only
recognizes and processes single AT-style commands. The unit treats compound AT
commands as unrecognized commands.
If the Full Verbose option is in effect, the unit responds to an unrecognized
command string that is otherwise formatted correctly (begins with AT and ends with
carriage return) with the "OK" message and takes no further action.
If the Numeric Response option is in effect, the unit responds to an unrecognized
command string that is otherwise formatted correctly with a "0" message and takes
no further action.
When an active connection is in effect, the unit transfers data and does not process
commands received from the serial interface.
When a connection is terminated or lost, the unit reverts to command mode.