Lincoln Electric SQUARE WAVE TIG 255 SVM100-A - Manual (Page 66)

SQUARE WAVE TIG 255
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
Return to Master TOC
F-25 TROUBLESHOOTING & REPAIR
ARC START TRIGGER CIRCUIT TEST (continued)
PROTECTION/SNUBBER
L9255
J10 J11 J12 J13
J14 J15
10J12
3J12 3J13
11J13
6. Test the resistance from 11J13 on the
projection/ snubber board to pin “D” on
the six pin amphenol receptacle. (Lead
#311). Also check resistance from 3J13
on the projection/snubber board to pin
“E” on the six pin amphenol receptacle.
(Lead #303).
FIGURE F.9 - PROTECTION/SNUBBER BOARD TEST POINTS.
FIGURE F.10 - ARC START TRIGGER CIRCUIT.
A. If zero ohms resistance is shown
test is okay. Proceed to projection/
snubber board test.
B. If resistance of any value is shown,
check wires and connections.