Lantronix DSTni-EX - Manual (Page 91)

83
Frame Reference Register
The Frame Reference register contains information of the current bit of the CAN message. A
frame reference pointer indicates the current bit position. This enables message tracing on bit
level.
Note: The reset value of this register’s bits is indeterminate.
Table 5-64. Frame Reference Register
BIT 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
OFFSET 7Ah
FIELD
STUFF_IND RX_BIT TX_BIT FR4 FR3 FR2 FR1 FR0 RX_MOD TX_MOD FRB5 FRB4 FRB3 FRB2 FRB1 FRB0
RESET − − − − − − − − − − − − − − − −
R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W
Table 5-65. Error Capture Register Definitions
Bits Field Name Description
15 STUFFIND Stuff Bit Inserted
1 = a stuff bit has been inserted.
0 = idle.
14 RX_BIT Bit State on the Receiver Line
13 TX_BIT Bit State on the Transmitter Line
12:8 FR[4:0] frame_ref_Field
This is the frame reference a incoming or outgoing CAN message.
It is coded as follows:
00000 = stopped
00001 = synchronize
00101 = interframe
00110 = bus_idle
00111 = start_of_frame
01000 = arbitration
01001 = control
01010= data
01011 = crc
01100 = ack
01101 = end_of_frame
10000 = error_flag
10001 = error_echo
10010 = error_del:
11000 = overload_flag
11001 = overload_echo
11010 = overload_del
Other codes are not used.
7 RX_MOD RX Mode
1 = receiving data.
0 = not in RX mode (transmitting or idle).
6 TX_MOD TX Mode
1 = transmitting data.
0 = not in TX mode (receiving or idle).